View M55310-16_290250.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

INCH-POUND MIL-PRF-55310/16H 23 April 2003 SUPERSEDING MIL-PRF-55310/16G 8 July 2002
PERFORMANCE SPECIFICATION SHEET OSCILLATOR, CRYSTAL CONTROLLED, TYPE 1 (CRYSTAL OSCILLATOR (XO)), 0.1 Hz THROUGH 80 MHz, HERMETIC SEAL, SQUARE WAVE, TTL This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product described herein shall consist of this specification and MIL-PRF-55310. Pin number 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Function NC NC NC NC NC NC B - (GND/CASE) OUTPUT NC NC NC NC NC B+
Inches .002 .018 .100 .150 .20
mm 0.05 0.46 2.54 3.81 5.1
Inches .27 .300 .44 .54 .887
mm 6.9 7.62 11.2 13.7 22.53
NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. Unless otherwise specified, tolerances are .005 (0.13 mm) for three place decimals and .02 (0.5 mm) for two place decimals. 4. All pins with NC function may be connected internally and are not to be used as external tie points or connections. FIGURE 1. Dimensions and configuration.
AMSC N/A 1 of 4 DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
FSC 5955
MIL-PRF-55310/16H REQUIREMENTS: Interface and physical dimensions: See figure 1. Mounting: See figure 1. Terminals: See figure 1. Seal: Hermetic in accordance with MIL-PRF-55310, maximum leakage rate 5 x 10-8 atm cc/s. Weight: 0.5 ounce, maximum. * Oscillator: Class 2 or any class 1 or class 3 oscillator meeting all class 2 requirements and verification tests specified herein and in MIL-PRF-55310. Calibration: Manufacturer calibrated. Screening: In accordance with MIL-PRF-55310, product level B or S, as applicable. Temperature: Operating: See table I. Storage: -62C to + 125C. Oscillator load: Standard TTL loads (see table I). Output waveform: Symmetrical square wave. Supply voltage: 5.0 V dc 10 percent. Input current: At designated supply voltage (see table I). Output frequency: Frequency as designated at time of acquisition (see table I). Output voltage: At designated TTL load (see table I). Logic 1: 2.4 V dc, minimum. Logic 0: 0.5 V dc, maximum. Rise and fall times: See table I. Duty cycle: See table I. Initial accuracy at reference temperature (up to 30 days after shipment): See table I. Initial frequency-temperature accuracy (one-half temperature cycle): Verification applicable. 1/ Frequency-temperature tolerance (one-half temperature cycle, referenced to frequency measured at +23C 1C, immediately prior to starting of the test): See table I. Measurements taken at ten equally spaced increments over the specified operating temperature range. 1/ 1/ For the purpose of transitioning this device to MIL-PRF-55310, `Frequency stability versus temperature' has been renamed `Frequency-temperature tolerance'. The verification requirements of `initial frequency-temperature accuracy (one-half temperature cycle)' shall apply except that frequency measurements shall be referenced to the frequency measured at +23C 1C (fref) instead of to the nominal frequency (fnom). 2
MIL-PRF-55310/16H TABLE I. Dash numbers and operating characteristics.
Dash number Output frequency range Input current max at 5.25 V 1% 1/ mA 158 158 94 94 70 70 30 30 65 65 Pulse characteristics Rise and fall times max ns 15 15 15 15 15 15 15 15 5 5 Duty cycle at 1.4 V Load max 2/ Initial accuracy ppm at +23C 1C 15 25 15 25 15 25 15 25 15 25 Frequency aging ppm/year after 30 days Frequency-temperature tolerance (ppm) -55C -55C -20C to to to +125C +105C +70C A percent 45 to 55 45 to 55 45 to 55 45 to 55 45 to 55 45 to 55 40 to 60 40 to 60 40 to 60 40 to 60 10 TTL 10 TTL 10 TTL 10 TTL 10 TTL 10 TTL 10 TTL 10 TTL 6 TTL 6 TTL 5 10 5 10 5 10 5 10 5 10 50 100 50 100 50 100 50 100 50 100 B 40 80 40 80 40 80 40 80 40 80 C 25 50 25 50 25 50 25 50 25 50
01 04 11 14 21 24 31 34 41 44
0.1 Hz to 250 Hz 0.1 Hz to 250 Hz 250 Hz to 150 kHz 250 Hz to 150 kHz 150 kHz to 5 MHz 150 kHz to 5 MHz 4 MHz to 20 MHz 4 MHz to 20 MHz 20 MHz to 80 MHz 20 MHz to 80 MHz
1/ 2/
Maximum input current for no load condition. Actual configuration of TTL loads must be added to determine power supply requirements. A TTL unit load is defined as: 1.6 mA sink, 0.04 mA source, and 2pF capacitance.
Frequency-voltage tolerance: 2 ppm maximum for a 10 percent change in supply voltage. Measurements taken at reference temperature and operating temperature range end points. Frequency aging: Measurements shall be taken at +70C 0.2C at intervals of not more than every 72 hours for 30 days minimum (see table I). 5 ppm per year, maximum 0.7 ppm per 30 days. 1.5 ppm per 90 days Terminal strength: Method 211 of MIL-STD-202, test condition C. Applied force: 2 pounds each terminal for 10 seconds. Bends: Five at 45 degrees each. Frequency-environmental tolerance: Not applicable. Vibration, sinusoidal: In accordance with MIL-PRF-55310 and method 204 of MIL-STD-202. Nonoperating: Test condition D. Operating: Not required. 10 ppm per year, maximum 1.5 ppm per 30 days 3 ppm per 90 days
3
MIL-PRF-55310/16H Ambient pressure: Nonoperating: In accordance with MIL-PRF-55310. Operating: Method 105 of MIL-STD-202, test condition C. Part or Identifying Number (PIN): Consists of "M" prefix followed by specification sheet number, a dash and coded alphas, and numeric number. See example: EXAMPLE M55310/16S 01 A XXXXXXXX
M prefix and specification sheet number Product level (S, B, or C) Dash number (see table I) Operating temperature range (A, B, or C) (see table I) Frequency The margins of this specification sheet are marked with asterisks to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue.
Custodians: Army - CR Navy - EC Air Force - 11 Review activities: Army - AR, MI, SM Navy - AS, CG, MC Air Force - 19, 99 NASA - NA
Preparing activity: Army - CR Agent: DLA - CC (Project 5955-0747)
4

▲Up To Search▲

Price & Availability of M55310-16

	To Download M55310-16 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .